Good morning Hardik,

Thanks for your question.

It's actually very convenient to have that USB port in the Ethernet module as you can just plug your PC in there and access the entire backplane as well as the Ethernet network.

Sincerely,

Shawn Tierney,
Instructor at The Automation School

Good afternoon Jayze,

Thank you for your comments and understanding – I'm hoping to have it fixed this weekend!

Thanks again,

Shawn Tierney,
Instructor at The Automation School

Good afternoon Dale,

Thanks for you comments and question.

Another student mentioned that earlier in the week and I am seeing that here as well and I'm waiting on our “quiz” vendor to fix this issue.

Until then we'll need to click on the next lesson on the left to proceed,

Thanks again,

Shawn Tierney,
Instructor at The Automation School

You're very welcome Nghia!

Shawn Tierney,
Instructor at The Automation School

Good morning Felipe,

Can you check your FactoryTalk Activations to see if your View Studio activation is there and valid?

Sincerely,

Shawn Tierney,
Instructor at The Automation School

Good morning Jayze,

I'm seeing the same issue here on my test account – I'm going to start troubleshooting the issue, but in the mean time you should be able to select the next lesson on the left to continue taking the course while I troubleshoot this issue.

Sincerely,

Shawn Tierney,
Instructor at The Automation School

Good morning Felipe,

Thanks for your question.

At the 8 minute mark in the video, right above the “apply” button, you'll see the “center of rotation” selection defaults to “center.”

Hope this helps!

Shawn Tierney,
Instructor at The Automation School